|
|
|
RESIDENTIAL ENERGY SAVING ATTIC ACCESS INSULATION PRODUCTS
|
Virtually eliminate heat loss and infiltration through your attic whole house fan cover.
Install an Attic Fan Cover on Your Whole House Fan and Start
Saving Money Today!
|
The Energy ShieldSeal A Fan (Attic Fan Cover) is a simple solution to a major problem in homes with attic whole house fans.Traditional whole house fans leak air between the attic and living spaces. This can result in dirty cold or hot attic air entering your home. On the other hand, air leakage through the whole house fan from your home can create a negative pressure in your home. This negative pressure can draw outside air into your home through your fireplace or other unsealed openings. Whether the external air enters your home from outside through unsealed openings or leaks through your whole house fan, it makes your air conditioning and heating unit run longer. In cold climates, infiltration of warm moist air into your attic can cause water damage through condensation and may create ice. Preventing attic air leaks into your living space is the most efficient way to lower your energy costs and prevent problems in your home or attic. |
Save up to 20% on HVAC Energy Costs by Air Sealing and Insulating your home.1 1 www.energystar.gov Energy Shield Seal A Fan--Whole House Fan Cover™The kit attaches to the attic side of the whole house fan frame. It, in effect, seals off the opening in your attic stopping either the superheated or super-cold air in the attic from invading the living area. It uses a hook and loop fastening system to attach the top which can be partially removed or detached completely from the fan perimeter wall. Now you can use the whole house fan cover to effectively seal and insulate your whole house fan. The Energy Shield Seal A Fan™ prevents radiant heat from entering your home in the summer and leaving your heated areas in the winter. The Energy Shield Attic Fan Cover provides an effective seal against drafts, heat/air conditioning loss and is an easy-to-install system. Order your Energy Shield energy saving attic access Seal A Fan unit now. Click on the BUY NOW BUTTON ON THE LEFT SIDE OF THIS PAGE. OR Click on the Contact US Button to order by phone. |
The Energy Shield attic fan cover may be installed on direct drive fans or belt drive fans. The kit fits two different sizes of the most common whole house fans in residential homes. The Energy Shield whole house attic fan cover will fit the following manufacturers fans that have a 24” blade or 30” blade: ♦ Master Flow Fans♦ Air Vent Fans♦ Dayton♦ Triangle EngineeringFits most other whole house fan manufacturer frames that measure approximately 28 inches square and 34 inches square. The frame can be slightly smaller or larger by one inch. Larger sizes and custom sizing are available upon request.Start Saving Money Today! Only $159.95 |
|
Send mail to
peswebsitemgr with questions or comments about this web site.
Site Use Intellectual Rights/Copyrights |
.htm_cmp_blocks110_vbtn.gif)
